2025-01-18, 10:29 AM
(This post was last modified: 2025-01-18, 01:26 PM by GuteLappen.)
Hi.
Root problem is that I can't connect to the Openplotter with VNC running on a RPI 5 + MacArthur HAT with the power module when the HDMI is not connected.
After researching this, most posts suggest setting the screen resolution to a fixed value, which I'v done, currently 1920x1080 (tried different ones with the same result).
When booting without HDMI connected:
Anyone with any ideas that can help me resolving this problem?
I'm not planning to have a screen connected to the RPI when installed in my boat.
Thanks!
Root problem is that I can't connect to the Openplotter with VNC running on a RPI 5 + MacArthur HAT with the power module when the HDMI is not connected.
After researching this, most posts suggest setting the screen resolution to a fixed value, which I'v done, currently 1920x1080 (tried different ones with the same result).
When booting without HDMI connected:
- I can't connect with VNC (works when HDMI is connected).
- I can't turn off the RPI cutting power to the Seatalk1 12v power (works when HDMI is connected).
- No video is displayed on the monitor if connecting the HDMI cable post of booting.
Anyone with any ideas that can help me resolving this problem?
I'm not planning to have a screen connected to the RPI when installed in my boat.
Thanks!