2025-07-28, 07:04 AM
This brilliant design looks like it might be just what I need for my open plotter installation on my boat.
The boat is a Tayana 37 pilot house cutter.
I want to install the Raspberry Pi 5 with an nvme base and a McArthur hat but want to break the components up into a couple of separate cases, connected by a ribbon cable, so that the total height of the components will fit in the nav desk on my boat.
It looks like I might be able to build a couple of cases by stacking up the right components of this design.
Does this seem like a reasonable idea using the parts you have already designed?
Thanks,
JohnÂ
s/v Active Transport
Marina del Rey, CA
The boat is a Tayana 37 pilot house cutter.
I want to install the Raspberry Pi 5 with an nvme base and a McArthur hat but want to break the components up into a couple of separate cases, connected by a ribbon cable, so that the total height of the components will fit in the nav desk on my boat.
It looks like I might be able to build a couple of cases by stacking up the right components of this design.
Does this seem like a reasonable idea using the parts you have already designed?
Thanks,
JohnÂ
s/v Active Transport
Marina del Rey, CA