Modular case for Raspberry Pi 5 + miscellaneous HATs

[jklewis]

Hi John.

I suppose is feasible as long as you print two bases and two lids to mount two separate cases.

Also you will need to open two slots to pass the ribbon cable.

(I don't know if there is any limitation to the ribbon cable length due to possible electromagnetic interference).

Good luck with your project!

Pablo.

Thanks, Pablo, for this helpful and prompt response and for pointing out a potential problem with using a ribbon cable to connecte the two boxes.  Ill post an inquiry about that posible problem and see what the experts on this forum have to say. 

John