Hey guys.
I remixed this case with this Raspberry Pi Touch 2 Display Case by RonnyS. This is the result, everything seems to work fine! I just did not have long enough screws thats why its all looks a bit wobbly right now.
All I did was change the baseplate of the Display-Case and adjust it in height. The Pi 5 is still connected with the M2,5 6+6 Spacers to the Display. All other parts of Nas' case attach flawlessy (obviously, because it is the same base).
If someone could measure me the thickness of the platine + tell me which spacers are used to fit the NVMe Base to the Pi 5, I could adjust that and also make a fitting Baseplate for NVMe Base+Pi5 as well. The design I have so far only uses the SD Card.
Thank you very much for the design of that case! I hope, what I am doing here is "legal" (I am new to this whole Remix-World)
Cheers
I remixed this case with this Raspberry Pi Touch 2 Display Case by RonnyS. This is the result, everything seems to work fine! I just did not have long enough screws thats why its all looks a bit wobbly right now.
All I did was change the baseplate of the Display-Case and adjust it in height. The Pi 5 is still connected with the M2,5 6+6 Spacers to the Display. All other parts of Nas' case attach flawlessy (obviously, because it is the same base).
If someone could measure me the thickness of the platine + tell me which spacers are used to fit the NVMe Base to the Pi 5, I could adjust that and also make a fitting Baseplate for NVMe Base+Pi5 as well. The design I have so far only uses the SD Card.
Thank you very much for the design of that case! I hope, what I am doing here is "legal" (I am new to this whole Remix-World)
Cheers