This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › MacArthur HAT › MacArthur HAT cases and enclosures
Modular case for Raspberry Pi 5 + miscellaneous HATs

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Modular case for Raspberry Pi 5 + miscellaneous HATs
obscenic Offline
Junior Member
**
Posts: 24
Threads: 5
Joined: Mar 2026
Reputation: 0
#48
2026-05-25, 03:56 PM
Worth noting for anyone wanting to print this. Whilst PETG is preferable for heat from the pi, the layer "holding bracket" needs to be printed from PLA or something more flexible than PETG because the release levers can crack after just a few uses.
Find
Reply


Messages In This Thread
RE: Modular case for Raspberry Pi 5 + miscellaneous HATs - by obscenic - 2026-05-25, 03:56 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)