Problems installing NMEA 2000 | you can not select GPIO

[aguglielmi]

Hello everybody

I'm trying to setup a new instal PI5 +NVVME + MacHartur HAT

When I try to install CAN COnnection adding a new MCP251xdf device I'm not able to select the power GPIO 25, I always get the message "you can not select GPIO to do this job.

Anu Idea will be appreciated

Regards

[Sailoog]

You are probably confusing GPIO 25 with pin 25. Use the columns BCM of this table: https://macarthur-hat-documentation.read...inout.html

[aguglielmi]

You are probably confusing GPIO 25 with pin 25. Use the columns BCM of this table: https://macarthur-hat-documentation.read...inout.html

Hello

Thanks a lot!