2017-07-23, 01:04 PM
Dear all
When starting Openplotter, in start up window I see all necessary services to be started.
As my system was only connected to gps antenna and AIS receiver the start up was running smooth.
After having connected the echosounder and the Vhf-radio via "USB to NMEA Serial Adaptor" from Digital Yacht, the run up routine stops at "Getting NMEA time.....".
I started again without these connections, it runs smooth again. Connecting after run up is possible and system works without problems.
My question is, does anybody know a work around solution, maybe to configure the system that it takes its NMEA time from GPS antenna by default? To connect and disconnect the USB plugs all the time is kind of annoying.
Ludwig
When starting Openplotter, in start up window I see all necessary services to be started.
As my system was only connected to gps antenna and AIS receiver the start up was running smooth.
After having connected the echosounder and the Vhf-radio via "USB to NMEA Serial Adaptor" from Digital Yacht, the run up routine stops at "Getting NMEA time.....".
I started again without these connections, it runs smooth again. Connecting after run up is possible and system works without problems.
My question is, does anybody know a work around solution, maybe to configure the system that it takes its NMEA time from GPS antenna by default? To connect and disconnect the USB plugs all the time is kind of annoying.
Ludwig