Hi
Looking for help or pointing in the right direction ?
PI5/Macarthur Hat all hardwired in vessel with - ST,I2C/1 Wire/NMEA 0183 all working (excellent piece of design once you get your head around it.)
I have struggled with Canbus/NMEA 2K for ages but finally got working but not sure if correct/doesn't seem right
The only way I can get an incoming connection to SignalK is to add the MCP251xfd to the PI5 Interface with Ip link set can0 .....
On re-boot I loose the interface, is this normal? I am assuming the MCP251xfd should be found on the SPI automatically at boot ?
I have tried to configure for the interface to be loaded at boot ie - /etc/network/interfaces without joy will be trying boot/config next but this to be honest is out of my depth.
Anyways virtual beer for anyone that can help or physical beer if you are around the Solent
Many thks for reading and TIA
Looking for help or pointing in the right direction ?
PI5/Macarthur Hat all hardwired in vessel with - ST,I2C/1 Wire/NMEA 0183 all working (excellent piece of design once you get your head around it.)
I have struggled with Canbus/NMEA 2K for ages but finally got working but not sure if correct/doesn't seem right
The only way I can get an incoming connection to SignalK is to add the MCP251xfd to the PI5 Interface with Ip link set can0 .....
On re-boot I loose the interface, is this normal? I am assuming the MCP251xfd should be found on the SPI automatically at boot ?
I have tried to configure for the interface to be loaded at boot ie - /etc/network/interfaces without joy will be trying boot/config next but this to be honest is out of my depth.
Anyways virtual beer for anyone that can help or physical beer if you are around the Solent
Many thks for reading and TIA
