This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[SOLVED] I broke node red :(
#1
I do not know what I managed to do but I have been unable to fix it ....
Node red dashboard or the flow screen no longer connects (no longer displays), the pi runs at between 30 and 40 % cpu load, I can get to the pi via vnc, I can run open plotter, everything seems to run except node red is somehow messed up. The problem happened under 0.14.1 but I have since upgraded to 0.14.4 and the problem persists.
The high cpu load comes from node red according to the task manager.
Is it possible that deploying 'stuff' can break node red ? I had an inactive flow page that I use to collect flows of interest and the problems seemed to start when I made that page active and deployed it.
Re-booting doesn't change anything.
Reply
#2
I have managed to recover from my screwup. It was a mistake to mark my inactive flow page as active.
Reply
#3
Marking as SOLVED, we need to clean the bug forum to go to beta Smile
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)