SignalK server freeze

[SVGrayling]

Running R Pi5, OpenPlotter 4.2.9 with Mac Arthur HAT and ICM-20948.

I was successful in sending the compass heading from ICM-20948-to Dashboard.  However, the data stream would run for about 60 seconds, freeze for 30 seconds, then it would resume for 60 sec and repeat the repeat the cycle over and over again.  I can see the data freezing and starting in SignalK Data/Browser window.  Have anyone experienced this or know of a fix?  Any help would be very much appreciated.

[Zahir]

Hi SVGrayling,
Spark and Zahir have similar issues with similar setup... so far no proper solution found. Have a look at below to see if your issue is similar:

https://forum.openmarine.net/showthread....8#pid37018

[SVGrayling]

Hi Raoul,

Thanks for pointing me to the other thread. I will respond there.

Duke