2018-07-08, 09:15 PM
(2018-07-06, 08:29 AM)Rooco Wrote:(2018-07-05, 10:11 PM)dlorrain Wrote: Hi,
I tried to install it on a fresh open plotter install on my new rpi 3+ and here is the error message : "
INFO: Loading driver "./i2c-gpio-param.ko".
insmod: ERROR: could not insert module ./i2c-gpio-param.ko: Invalid module format
******************************************************************************************
ERROR occured!!
Could not load "./i2c-gpio-param.ko".
I tried to install it manually and same error Invalid module format
Any idea ?
Thanks
Hello!
Which OpenPlotter image are you using?
Have you compiled the Moitessier tools at your own or do you use the precompiled debian package included in the OpenPlotter image?
This error occurs if the kernel and the modules used by the Moitessier HAT are compiled with a different compiler. The Moitessier modules are loaded dynamically upon booting, so it is essential that they have the same format. If you want to compile the tools/drivers at your own use the official compiler provided by Raspberry.
Regards,
Thomas
Hi,
Very strange I am using the OpenPlotter v1.0.0 IMG downloaded from this website...
I will reinstall it and see if I have the same issue.
Regards.
D.