dAISy Hat setup Help

[DyslexicDancer]

I'm trying to get openplotter set-up with a dAISy Hat Dual Channel AIS receiver, I have it connected to a Raspberry Pi 3

I've run the Ilker Temir script in the email they sent me, and I think it worked because now I do not have bluetooth anymore, so i think the serial port is available now

But for the life of me I do not understand how I'm suppose to get the dAISy hat to communicate with Openplotter

I think the dAISy Hat is working fine because every 5 or so seconds I get the green LED light flash, but when i look in openplotter I do not see that it has a connection

I've tried setting up a new connection under the NMEA 0183 tab, (Type:Serial Name:ais, Port:ttyS0 Baud:38400 in/ot:in) but no dice

I'm a total noob when it comes to the Raspberry Pi and Linux

Any help would be greatly appreciated

TIA
Tim

[Sailoog]

You have to be sure that those are the correct port and bauds.

Opencpn should be listen to TCP localhost 10109

You can try the auto setup. Go to Tools - Auto Setup - start - setup and see what happens.

[DyslexicDancer]

got it working, I had to connect it to the ttyAMA0 port for Openplotter to see the NMEA data

I guess the issue was that the AIS hat is silent, so i had to put it in test mode to configure the port

All is working now

Thanks