This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Calibration failed
#11
(2016-03-30, 04:14 PM)Didier B Wrote: Did you tried this calibration process with the V0.7.1 or V0.8.0 ?

I don't remember but I will repeat again on v0.8.0 for 9250 to be sure ASAP.
Reply
#12
(2016-04-03, 11:52 AM)Sailoog Wrote:
(2016-03-30, 04:14 PM)Didier B Wrote: Did you tried this calibration process with the V0.7.1 or V0.8.0 ?

I don't remember but I will repeat again on v0.8.0 for 9250 to be sure ASAP.
I tried to calibrate both iMU in 0.7.1 without success
My last try was with 0.8.0 and 9150. I will try with 0.8.0 and 9250 and report ASAP

Edit : tested 9250 with 0.8.0 : failure again ...
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN  5.8.4 :  Thank you  Thank you  Thank you


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)