Yes, I press the button "process elipsoid" when values were over 200 ...
Unfortunately, my MPU9150 deceased for an unknown reason when I tried the Nth iteration of the calibration process.
It happened after I changed the screws from steel to brass ones. Did I applied a too strong constraint ? Or did I made a lethal short circuit ?
The sensor is recognized in OP's I2C tab, but inspector only shows "NaN" instead of values for HDG, Pitch and Heel (while pressure, humidity and temperature sensors are properly read).
More on the matter when postman will have delivered my freshly ordered MPU9250 !
Unfortunately, my MPU9150 deceased for an unknown reason when I tried the Nth iteration of the calibration process.
It happened after I changed the screws from steel to brass ones. Did I applied a too strong constraint ? Or did I made a lethal short circuit ?
The sensor is recognized in OP's I2C tab, but inspector only shows "NaN" instead of values for HDG, Pitch and Heel (while pressure, humidity and temperature sensors are properly read).
More on the matter when postman will have delivered my freshly ordered MPU9250 !
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you