Calibration failed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Calibration failed

Didier B Offline

Senior Member

Posts: 340
Threads: 72
Joined: Mar 2016
Reputation: 12

#10

2016-03-30, 04:14 PM

(2016-03-30, 11:23 AM)Sailoog Wrote:
(2016-03-29, 03:34 PM)Didier B Wrote: re tested calibration with both types of IMU, 9150 & 9250, no success...

I have no problem with 9250, so I think you should check your wiring. Calibration process involves shaking the module and if you are suffering micro interruptions in your connections that could cause errors. Once happened to me.

Thanks for your support. Last test I did was with a 9150 soldered via a 5 m cable. Results are highly reproducible : all the calibration process is OK, excepted the Ellipsoid phase which fails constantly. I'd rather suspect a S/W issue : missing file or a path problem ... Did you tried this calibration process with the V0.7.1 or V0.8.0 ?

Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you

Find