This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
i2c conflicts?
#1
I updated to 0.17.0 today, but couldn't get the MPU-6050 working. In the past it has been recognized as MPU-9150. 

After switching sensors, I finally realized that the Pi doesn't recognize the MPU-6050 if the BME280 and HTU21D are installed.   i2cdetect -y 1 only shows the the HTU21d at address 40, and the BME280 at address 76. 

If I reboot and remove the BME280, the MPU-6050 is recognized at address 68 and works fine.  

Anybody else run into that? It seems there was a similar problem in the past.. any ideas?

Many thanks.

Hank
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)