2018-02-07, 09:55 AM
(2018-02-06, 09:08 PM)Sailoog Wrote:(2018-02-06, 02:33 PM)Journeymen361 Wrote: Struggled in the beginning with the same problems with no connect as mentioned but finally also managed to get the data stream alive...
By far from what I found the best tool to setup and view individual gauges! Should be available in Openplotter from the very beginning in my point of view. Still some more updates to come (hopefully) such as for e.g. "Humidity in %" as a dedfined value in the dropbox list, currently not available. Also experienced some latency issues with the 1W sensor.... I2C data is shown immediately while 1W in average take 30-60 seconds until data is getting in...
this is normal, 1W sensors send data every 60 seconds
Hmmmm, disagree from my experience.... - The refresh rate of the 1W should be quicker than 60 seconds, should'nt it? When I use the Signal K diagnostic in Openplotter I immediately get the values shown both for 1W and I2C and they get updated second by second, it's just in the KIP that I have a delay with the 1W - It's no big deal though and I'm now used to it, but interesting....