2019-05-31, 04:58 PM
Hi all,
I would like some help please if there is anyone who can guide me on how to connect the tinypilot computer i purchased from sean to my cytron 13a motor controller from robotshop.com.
The controller has gnd, 1x pwm and 1x dir connections.
I have tried unsuccesfully to upload pypilot motor.ino to arduino but cannot get it to compile after many attempts.i have very little arduino coding knowledge and was hoping there is another way to get the controller talking to the tinypilot.
Any advice greatly appreciated.
Thanks
I would like some help please if there is anyone who can guide me on how to connect the tinypilot computer i purchased from sean to my cytron 13a motor controller from robotshop.com.
The controller has gnd, 1x pwm and 1x dir connections.
I have tried unsuccesfully to upload pypilot motor.ino to arduino but cannot get it to compile after many attempts.i have very little arduino coding knowledge and was hoping there is another way to get the controller talking to the tinypilot.
Any advice greatly appreciated.
Thanks