OpenMarine

Threads

1. Wired ethernet link between Tinypilot and Openplotter Raspberry (15 Replies)
2. MPU-9250 not detected (33 Replies)
3. ICM-20948 (QWIIC) setup or standard i2c (22 Replies)
4. Tinypilot on Pi Zero (non-wifi) to replace ST2000+ controller (4 Replies)
5. New Py Zero 2 W is Out! (108 Replies)
6. Connect IMU to pyPilot through TTL over USB (5 Replies)
7. TensorFlow, AI, Autopilot, VendeeGlobe (5 Replies)
8. Pilot for steel sailing boat 60ft 50Gt with 24v hydraulic pump (0 Replies)
9. Tinypilot expected behavior with activated route (24 Replies)
10. LCD JLX12864 flashing (34 Replies)
11. motor controller schematics (0 Replies)
12. pypilot on opencpn using w2k-1 actisense nmea wifi gateway (9 Replies)
13. Pypilot Hat (1 Reply)
14. Rudder Sense Resistor Network (1 Reply)
15. Connect pypilot to a router (1 Reply)
16. IMU calibration (2 Replies)
17. OpenPlotter - PyPilot - TinyPilot (14 Replies)
18. Tinypilot manual control with RF remote device (4 Replies)
19. Weather sensor with display crashing in OpenCPN (4 Replies)
20. V belt too much slippage? (1 Reply)