OpenMarine

Hi,

I wanted to use a RPI3B+ in my shipsytem, currently running on RPI3, so I did a new install on USB using noobs in the RPI3B+.
After installation everything Ok, updated using openplotter update button, after update no hdmi connection.
During start-upI see the splash screen, followed by the Noobs recovery page, then start-up auto continues, but screen blanks.
OP can be connected through VNC, sits in low resolutipn and will not change resolution.
Any Ideas?

You can try to change the resolution with sudo raspi-config.

(2019-08-09, 10:44 PM)e-sailing Wrote: [ -> ]You can try to change the resolution with sudo raspi-config.

That worked, thanks, problem solved!