Need help setting up Pypilot - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: Pypilot (https://forum.openmarine.net/forumdisplay.php?fid=17) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=18) +--- Thread: Need help setting up Pypilot (/showthread.php?tid=1628) |
Need help setting up Pypilot - ddelorme - 2019-01-06 I need a little help getting the motor controller working. I have the serial connected to a serial to USB adaptor. USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi PRODUCT ID: 954 4pin connector USB adaptor brown vcc Red +5v black GND Black GND white RX Green TX blue TX White RX Power to Controller 1 long beep Bullet connectors to motor. I see the USB device cat /dev/ttyUSB1 nothing Device setup in openplotter name device assignment Servo /dev/ttyUSB1 pypilot When I enable basic autopilot In openplotter/pypilot I lose GPS? What did i mess up? RE: Need help setting up Pypilot - ddelorme - 2019-01-06 From Pypilot Code: Using settings file RTIMULib.ini Code: pypilot_servo RE: Need help setting up Pypilot - ddelorme - 2019-01-09 All fixed Crappy pico usb caused most of the issues... Dont buy one |