2018-01-05, 03:37 PM
Hi,
I just moved to OP 0.10.0 Alpha (from a much older OP version), and am struggling with setting up GPIO actions.
What worked previously is not working now...
I am looking to trigger a system shutdown when GPIO27 is connected to GND
I've set it up as below for testing:
However, when I connect Pin9 (GND) to Pin13 (GPIO27) nothing happens.
This used to work in the older version I was running (although the setup was slightly different).
What am I doing wrong here?
I just moved to OP 0.10.0 Alpha (from a much older OP version), and am struggling with setting up GPIO actions.
What worked previously is not working now...
I am looking to trigger a system shutdown when GPIO27 is connected to GND
I've set it up as below for testing:
However, when I connect Pin9 (GND) to Pin13 (GPIO27) nothing happens.
This used to work in the older version I was running (although the setup was slightly different).
What am I doing wrong here?