Posts: 327
Threads: 20
Joined: Apr 2016
Reputation:
10
Just did the latest update of MXTommy. However MXTommy did not start in OpenPlotter. Not with localhost or 127.0.0.1.
Using MXTommy from another system with Ip adres of the OpenPlotter RPI it does work.
If I use the same adress 192.168.1.146 in OpenPlotter MXTommy also works.
There is something missing.
Bram
Posts: 287
Threads: 44
Joined: Mar 2016
Reputation:
5
Works fine at my install.
Have you checked /etc/hosts file
Mine looks like this:
127.0.0.1 localhost
::1 localhost ip6-localhost ip6-loopback
ff02::1 ip6-allnodes
ff02::2 ip6-allrouters
127.0.1.1 openplotter
10.10.10.1 openplotter.local openplotter
Posts: 327
Threads: 20
Joined: Apr 2016
Reputation:
10
2019-10-12, 12:11 PM
(This post was last modified: 2019-10-13, 08:58 AM by verkerkbr.)
It worked fine before. But after the (SignalK) MxTommy upgrade to 0.1.12. But if I use the signalK Ip adres then it is working.
Posts: 287
Threads: 44
Joined: Mar 2016
Reputation:
5
don't know if there is somewhere a dedicated MXTommy thread - so allow me to raise a question here ( or move to ? )
- how can coordinates get displayed. I tried "numeric" and "unitless" but that does not display e.g. the position satisfying.
Can anyone advise how to configure displaying position data with Degree Minutes.dec N/S or E/W ?
Posts: 327
Threads: 20
Joined: Apr 2016
Reputation:
10
MxTommy works very well. Problem with the network settings is not yet solved.
Changing the format of the position data seems allready solved in another application: Instruments.
It is a bit hidden. But if you click on the small icon in the upper left corner, you can change the position data format.
It seems to me, not to be difficult to add this option to MxTommy KIP.
Posts: 287
Threads: 44
Joined: Mar 2016
Reputation:
5
When I use the link 10.10.10.1:3000/@mxtommy/kip/#/page/0 on another devise the "customization" of my configuration is not carried over.
Can anyone advise how to copy the configuration to another e.g. android phone or tablet?
Posts: 799
Threads: 46
Joined: Jun 2017
Reputation:
25
2019-12-06, 02:42 PM
(This post was last modified: 2019-12-06, 03:06 PM by jim321.)
as for networking
from the pi directly ssh or vnc 127.0.0.1 or localhost or 10.10.10.1 should work.
if connected to the pi's ap with another device
use 10.10.10.1
if connected to another network say pi Ethernet to router you need to use the ip the router assigned to it like 192.168.x.x if you connect thru that network.
openplotter makes a network @10.10.10.1 if you connect to a network with 192.168.x.x.it wont see the 10.10.10.1 localhost network. and it will use the 192.168.x.x to query any web page that openplotter host's
i hope i explained that ok