As you know the Raspberry Pi 4 forced us to redesign the Moitessier HAT and enclosure. Both of them are already in manufacturing and we expect to start selling them in January.
It contains the same chips and features but there are few changes:
We are working on an unique driver for Raspberry 3 and 4. When this is done you will found it here: https://www.rooco.eu/2018/06/13/firmware...ssier-hat/
The new Moitessier HAT 2 will be back in stock on 17th January 2020. Back orders are allowed.
It contains the same chips and features but there are few changes:
- We have changed the shape so it can be attached to Rapsberry Pi 3 and Raspberry Pi 4.
- There is a switch to turn OpenPlotter off. To turn OpenPlotter on again you need to un- and replug the power supply. The button is connected to the microcontroller on the HAT. If it is pressed a special command is sent to the Pi. The driver on the Pi recognizes the command and will automatically execute the shutdown command. So no need to configure anything in OpenPlotter.
- Now the PCB is blue.
We are working on an unique driver for Raspberry 3 and 4. When this is done you will found it here: https://www.rooco.eu/2018/06/13/firmware...ssier-hat/
The new Moitessier HAT 2 will be back in stock on 17th January 2020. Back orders are allowed.