(2020-01-12, 11:53 AM)Sailoog Wrote: What you should test:
- Uninstall MCS and try to get moitessier hat working. You can use a fresh openplotter pre-release image.
- After having the hat working install MCS app and lets see what happens
- If it does not work, copy here the contents of the file /boot/config.txt
Hi Sailoog, I tried as you say. Everything ok without the MCS card. As I put it all on the MCS returns the warning in red of the SPI- So I assume that the conflict is with the MCS card. Here is "config.txt". A nice mess! You don't have MCS and Glowntiger is waiting for the new Moitessier cap ... hopefully you can solve it!
# For more options and information see
#
http://rpf.io/configtxt
# Some settings may impact device functionality. See link above for details
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16
# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4
# uncomment for composite PAL
#sdtv_mode=2
#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800
# Uncomment some or all of these to enable the optional hardware interfaces
dtparam=i2c_arm=on
#dtparam=i2s=on
dtparam=spi=on
# Uncomment this to enable infrared communication.
#dtoverlay=gpio-ir,gpio_pin=17
#dtoverlay=gpio-ir-tx,gpio_pin=18
# Additional overlays and parameters are documented /boot/overlays/README
# Enable audio (loads snd_bcm2835)
dtparam=audio=on
[pi4]
# Enable DRM VC4 V3D driver on top of the dispmanx display stack
dtoverlay=vc4-fkms-v3d
max_framebuffers=2
[all]
#dtoverlay=vc4-fkms-v3d
enable_uart=1
gpu_mem=100
dtoverlay=i2c-gpio,i2c_gpio_sda=2,i2c_gpio_scl=3,bus=3
#MCS-Openplotter config (Do not delete or edit this part)(start)
dtoverlay=sc16is752-i2c,int_pin=13,addr=0x4c,xtal=14745600
dtoverlay=sc16is752-i2c,int_pin=12,addr=0x49,xtal=14745600
dtoverlay=sc16is752-i2c,int_pin=6,addr=0x48,xtal=14745600
#MCS-Openplotter config (Do not delete or edit this part)(end)
dtoverlay=mcp2515-can1,oscillator=16000000,interrupt=25
dtoverlay=w1-gpio