2019-01-06, 02:54 PM
I need a little help getting the motor controller working.
I have the serial connected to a serial to USB adaptor.
USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi
PRODUCT ID: 954
4pin connector USB adaptor
brown vcc Red +5v
black GND Black GND
white RX Green TX
blue TX White RX
Power to Controller
1 long beep
Bullet connectors to motor.
I see the USB device
cat /dev/ttyUSB1 nothing
Device setup in openplotter
name device assignment
Servo /dev/ttyUSB1 pypilot
When I enable basic autopilot In openplotter/pypilot I lose GPS?
What did i mess up?
I have the serial connected to a serial to USB adaptor.
USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi
PRODUCT ID: 954
4pin connector USB adaptor
brown vcc Red +5v
black GND Black GND
white RX Green TX
blue TX White RX
Power to Controller
1 long beep
Bullet connectors to motor.
I see the USB device
cat /dev/ttyUSB1 nothing
Device setup in openplotter
name device assignment
Servo /dev/ttyUSB1 pypilot
When I enable basic autopilot In openplotter/pypilot I lose GPS?
What did i mess up?