2018-06-10, 01:52 PM
I’m trying to get VNC viewer working. I get m4ssage that user or password is invalid. I can log on to the openploter network just fine. I have reset password and I’m using user name “pi”. I have run out of ideas?
VNC on iPad.
|
2018-06-10, 01:52 PM
I’m trying to get VNC viewer working. I get m4ssage that user or password is invalid. I can log on to the openploter network just fine. I have reset password and I’m using user name “pi”. I have run out of ideas?
2018-06-10, 02:57 PM
I just downloaded VNC Viewer to the iPad and it works OK. Could you perhaps post a screenshot of the failure?
2018-06-10, 03:55 PM
Same here, all works fine on my iPad with VNC viewer. Make sure you have enabled VNC in Raspberry options, then the correct ip, and then login: pi; password: raspberry
2018-06-10, 07:07 PM
(2018-06-10, 03:55 PM)Barentsailor Wrote: Same here, all works fine on my iPad with VNC viewer. Make sure you have enabled VNC in Raspberry options, then the correct ip, and then login: pi; password: raspberry I get on the iPad, “ERROR username was recognized or paswatd was incorrect” I have reset paswarded and reboot but still get the same thing. I can look into theip’s nework ok.
2018-06-10, 07:20 PM
Well I still think a screenshot of the error might help.
2018-06-10, 08:18 PM
Again
Photo to large to upload.
2018-06-10, 09:09 PM
have you change the password , using some special national characters ?
Apple ( ios) and Linux use diferent code pages . i have seen this problem with some routers .
Sailing in a LM23 23" motor sailor i Danmark . Mostly In Koege bay .
Harbored in SF-Syd , Copenhagen . Marine Enginer , Pt. working on power plant
2018-06-10, 09:51 PM
I don’t think so? It is the password used to log into the WiFi on the pi? Or is it the VNC account password?
|
« Next Oldest | Next Newest »
|