2021-08-14, 12:36 PM
(2021-08-14, 11:36 AM)baltika_no_9 Wrote: Ah that rings a bell! I had that I'm sure, let me consult my notes.
Do you have GB set up as the wifi country in the Raspberry Pi Localisation page?
What is in the file /etc/wpa-supplicant/wpa_supplicant.conf ?
Ok,
So just to update you I have tried a fresh install of OpenPlotter and, even before I update (apart from changing the pi and wifi passwords) the symptom is just the same.
You asked about wifi country. I tried to update this and did not receive any error message but on exiting Raspberry Pi configuration and opening again it still shows as <not set>.
/etc/wpa_supplicant/wpa_supplicant.conf contains:
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1