This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
BMP180 Pressure Sensor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
BMP180 Pressure Sensor
chris3333 Offline
Junior Member
**
Posts: 4
Threads: 1
Joined: Mar 2018
Reputation: 0
#4
2018-03-21, 12:04 PM
(2018-03-20, 09:55 AM)chris3333 Wrote:
(2018-03-19, 06:58 PM)Sailoog Wrote: You have to set the sensor on I2C tab to generate signal k data before converting to NMEA 0183

Thank you for reply. I did that already, but i got only 0 Values in the NEMA Stream. AIS is working fine. The Sensor was running well with your Version 0.12.0 . Is it possible that the pi has power issues?


Thank you,

Christian

here some screenshots:


Attached Files Image(s)
           
Find
Reply


Messages In This Thread
BMP180 Pressure Sensor - by chris3333 - 2018-03-18, 12:15 PM
RE: BMP180 Pressure Sensor - by Sailoog - 2018-03-19, 06:58 PM
RE: BMP180 Pressure Sensor - by chris3333 - 2018-03-20, 09:55 AM
RE: BMP180 Pressure Sensor - by chris3333 - 2018-03-21, 12:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)