This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Bug Reports v
IMU and Temp/Hum sensor interference

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
IMU and Temp/Hum sensor interference
Snijdor Offline
Junior Member
**
Posts: 11
Threads: 4
Joined: Jul 2016
Reputation: 0
#1
2016-08-10, 08:47 PM (This post was last modified: 2016-08-10, 10:10 PM by Snijdor.)
Hello,

When I connect both the IMU and Temp/Hum sensor I get random garbled values on the temp/hum. When I disconnect or disable the IMU I get normal values on Temp/hum.
After a reset and restart the temp/hum is not detected anymore.

I've wired the SDA SDC tight together, I use a MPU-9250 IMU sensor and HKU and a HTU21D Temp/hum sensor.

Any ideas?

Regards
Find
Reply


Messages In This Thread
IMU and Temp/Hum sensor interference - by Snijdor - 2016-08-10, 08:47 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)