new case for my pi4 Need suggestions for 1wire port and connectors

[ddelorme]

I am designing a new case for my RPi4.. I am using a molex .093 2 pin connector for the power and molex mini fit .062 2 pin for reset/shutdown button and anchor light. The 1wire is a pain as it is very small gage i tried a molex but it is too big. I and now tiring rj11 jack.. I hope it will work
Suggestions are welcome
here is a picture of the case.
it has a 52pi.cn protohat on it with the imu and a connector for an i2c temp/humity/pressure sensor.