This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OP2 pypilot 2.0.6 RPI4
#3
(2020-02-15, 03:46 AM)seandepagnier Wrote: I suggest posting on pypilot forum, but basically there is no autocenter feature unless you click the "center" button.   I"m not sure what is going on, but pypilot should never move the motor unless engaged or a manual command.

Sean,

I have noticed a similar thing. If you restart the pi or nano the actuator clutch clicks a few times, but the actuator does not move.

Messed around with it a bit and it appears when the clutch clicks a few times when the serial connection between the pi and the nano is made.
Reply


Messages In This Thread
OP2 pypilot 2.0.6 RPI4 - by ddelorme - 2020-02-15, 12:37 AM
RE: OP2 pypilot 2.0.6 RPI4 - by seandepagnier - 2020-02-15, 03:46 AM
RE: OP2 pypilot 2.0.6 RPI4 - by Opie91 - 2020-02-15, 03:30 PM
RE: OP2 pypilot 2.0.6 RPI4 - by seandepagnier - 2020-02-15, 04:09 PM
RE: OP2 pypilot 2.0.6 RPI4 - by Opie91 - 2020-02-15, 04:42 PM
RE: OP2 pypilot 2.0.6 RPI4 - by seandepagnier - 2020-02-16, 02:07 AM
RE: OP2 pypilot 2.0.6 RPI4 - by ddelorme - 2020-02-16, 12:23 AM
RE: OP2 pypilot 2.0.6 RPI4 - by Opie91 - 2020-02-16, 02:50 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)