2020-03-30, 08:28 PM
(2020-03-30, 06:21 PM)luchin0 Wrote:Ciao, in OP you have to go to Serial and add the new port. Obviously, if there are no Setalk instruments attached, nothing will happen. The new door, however, you should also see it in signalK ready for use! Not being bidirectional, it is not a good idea to add the autopilot.(2020-02-23, 04:20 PM)Max1947 Wrote:Finally today has arrived the stuff to convert nmea1 signal.(2020-02-23, 12:11 PM)luchin0 Wrote: Thank you.
This one can make the work? https://www.painestore.it/convertitore_s...vMEALw_wcB
Something cheaper exists?
I though it was 1 camble for wind and 1 for depth... But i never check. Next time i will
Inviato dal mio ANE-LX2 utilizzando Tapatalk
Hi, you should use this. It's also cheap ... good wind!
Http: //yakbitz.com/ST1toNMEA.aspx
I try it immediatly. Connecting it to my pc, it doesn't recognize it... It's becouse there are nothing attached?
Becouse of corona virus restriction i don't think i can go to my boat in a short time to connect it to my instrument, how can i check if everything works?
There's some drive i have to install? I searched via google but i can't find any information...
Inviato dal mio ANE-LX2 utilizzando Tapatalk
And stay in the house, the time will come to try everything on the boat as soon as the war with the virus is won!