2020-02-25, 07:13 PM
(This post was last modified: 2020-02-25, 07:16 PM by carlos-palma.)
(2020-02-24, 04:06 PM)Sailoog Wrote: What is the model of your pressure, temperature sensor?Thanks for your answer!
what means "nothing happens" when you open I2C?
My imu is reported by pypilot as: Invensense MPU-9250/MPU-9255, the printed circuit reads MPU-92.65
It was working fine with openplotter older versions.
When I click I2C I was expecting to open a window to see the detected sensors, calibration, etc, but nothing opens. I can see the clock as doing something but after a few seconds it is over with no visible result.
I did un-install and re-install I2C twice with no results.
Thanks for your help,
Carlos.
(2020-02-24, 04:06 PM)Sailoog Wrote: What is the model of your pressure, temperature sensor?Thanks for your answer!
what means "nothing happens" when you open I2C?
My imu is reported by pypilot as: Invensense MPU-9250/MPU-9255, the printed circuit reads MPU-92.65
It was working fine with openplotter older versions.
When I click I2C I was expecting to open a window to see the detected sensors, calibration, etc, but nothing opens. I can see the clock as doing something but after a few seconds it is over with no visible result.
I did un-install and re-install I2C twice with no results.
Thanks for your help,
Carlos.