2017-05-24, 11:45 AM
my system consistence of RP3, pico ups with a sense hat on top. I ave just installed it on my first sailboat Tanser 26. I had several issues setting this up at home due to houses are full of interference. But on the boat it is fine. The pico allows me to turn the power off to the boat then five minutes later it. shuts down the pi. Some of the previous issues with OP have been fixed with 0.11.7. I will summit pictures as soon as i complete the project.
I found that sending data to the little lcd screen on the Sense hat with node red used a lot of processor power and was not that useful. The pi would have to be seriously water proofed if i exposed it. I am now tiring to decide what to use for a display. I am leaning towards a tablet via vnc for the outside and a hdmi touch screen for the inside.
I found that sending data to the little lcd screen on the Sense hat with node red used a lot of processor power and was not that useful. The pi would have to be seriously water proofed if i exposed it. I am now tiring to decide what to use for a display. I am leaning towards a tablet via vnc for the outside and a hdmi touch screen for the inside.