i have ordered a breakout terminal hat it has a proto board section and i plan on putting a MCP3008 adc and screw terminals on there.
i would also like to add can bus is the MCP2551 can bus a good chip to use for this ?or do i need the controller chip also.
i am planning to connect it to uart pins on pi dev/ttyS0 .. would that work out?
Thanks
Jim
i would also like to add can bus is the MCP2551 can bus a good chip to use for this ?or do i need the controller chip also.
i am planning to connect it to uart pins on pi dev/ttyS0 .. would that work out?
Thanks
Jim