2021-04-23, 02:43 PM
Maybe I misunderstood the functionality of using the UTP-port when enabling "Add Ethernet port to AP", but this is what I experience:
I have OP2 running on a RPi4 with 4 GB.
App 'Network' is version 2.1.5
Has been working for more then a year on my boat to full satisfaction, with a second (USB) WiFi-antenna.
The internal WiFi is my AP and the external connects to the marina WiFi.
My plan was to connect a camera directly to the UTP-port of the Pi and bridge the port to the AP. So just one check-mark and a reboot and voila: camera was working!
But the Pi crashes within two minutes, each time after reboot
Well, it seems to still be running but WiFi fails so I cannot check anything.
Should my setup be possible or is it not intended to be used like this?
p.s. I gave the camera a fixed IP-address in the range of the WiFi-network.
Ed
I have OP2 running on a RPi4 with 4 GB.
App 'Network' is version 2.1.5
Has been working for more then a year on my boat to full satisfaction, with a second (USB) WiFi-antenna.
The internal WiFi is my AP and the external connects to the marina WiFi.
My plan was to connect a camera directly to the UTP-port of the Pi and bridge the port to the AP. So just one check-mark and a reboot and voila: camera was working!
But the Pi crashes within two minutes, each time after reboot
Well, it seems to still be running but WiFi fails so I cannot check anything.
Should my setup be possible or is it not intended to be used like this?
p.s. I gave the camera a fixed IP-address in the range of the WiFi-network.
Ed