2018-01-05, 03:37 PM
Hi,
I just moved to OP 0.10.0 Alpha (from a much older OP version), and am struggling with setting up GPIO actions.
What worked previously is not working now...
I am looking to trigger a system shutdown when GPIO27 is connected to GND
I've set it up as below for testing:
![[Image: 2018-01-05_15h23_37.png]](http://guldburken.gote.org/op/2018-01-05_15h23_37.png)
![[Image: 2018-01-05_15h25_18.png]](http://guldburken.gote.org/op/2018-01-05_15h25_18.png)
However, when I connect Pin9 (GND) to Pin13 (GPIO27) nothing happens.
This used to work in the older version I was running (although the setup was slightly different).
What am I doing wrong here?
I just moved to OP 0.10.0 Alpha (from a much older OP version), and am struggling with setting up GPIO actions.
What worked previously is not working now...
I am looking to trigger a system shutdown when GPIO27 is connected to GND
I've set it up as below for testing:
![[Image: 2018-01-05_15h23_37.png]](http://guldburken.gote.org/op/2018-01-05_15h23_37.png)
![[Image: 2018-01-05_15h25_18.png]](http://guldburken.gote.org/op/2018-01-05_15h25_18.png)
However, when I connect Pin9 (GND) to Pin13 (GPIO27) nothing happens.
This used to work in the older version I was running (although the setup was slightly different).
What am I doing wrong here?