This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
actions, Execute Command, Displaying a message

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
actions, Execute Command, Displaying a message
jim321 Offline
Moderator
*****
Posts: 800
Threads: 46
Joined: Jun 2017
Reputation: 25
#4
2019-04-10, 02:50 PM (This post was last modified: 2019-04-10, 02:55 PM by jim321.)
see if this fixes it..

sudo npm install serialport --unsafe-perm --build-from-source

i have tested it with inject but i don't have cec-utils installed so the command has nothing to start..but i see the command sent.

i updated the code to include inject debug..
Find
Reply


Messages In This Thread
RE: actions, Execute Command, Displaying a message - by jim321 - 2019-04-10, 02:50 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)