2020-01-21, 03:44 PM
(2020-01-21, 12:21 PM)Sailoog Wrote: Yes, that is the expected behavior. Last night the Raspbian kernel changed from 4.19.75 to 4.19.93. your driver must match the kernel version. Kernel may be updated with "sudo apt update". Raspberry.org updates the kernel once per 1/2 month. The rooco servers will detect these kernel updates and will build automatically the new driver to be downloaded. It will take some hours to be available.
The new driver for 4.19.93 and previous kernels is already available, try again.
Craig in this new driver the SPI issue is solved, please try again and report.
OK,
I did a shift reset of the system, let it re-install the starter version. Installed all the Pi updates and rebooted. Activated the SPI, i2c and VNC interfaces. Installed the Moitessier App, installed the latest 4.19.93 driver in the Moitessier App. It rebooted at the end of the driver install with the message to e-run the script after reboot and went back into a boot loop. At boot up, it loads up to the systemd-user-sessions.service and then hangs. I just followed the instructions. I noticed in the instructions it doesn't mention about the reboot requirement for the driver or the message to re-run the script that appears in the last line of the Moitessier App. It just keeps crapping out whenever I try and install it. It was all working fine on OP1, so I don't think it's a hardware issue.