This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
RPI in marine environment, rust, corrosion, cases, etc.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
RPI in marine environment, rust, corrosion, cases, etc.
w7thmark Offline
Junior Member
**
Posts: 25
Threads: 7
Joined: Dec 2019
Reputation: 0
#1
2020-01-08, 05:44 PM
Rapidly learning about OP and the RPI and beginning to think about how I will integrate into my sailboat.  Everything will be mounted below deck, but even so, how much should I be worried about corrosion, rust, etc.?  Are longtime users doing OK with their RPIs in enclosures that are not completely sealed from salt air?   ....or should I be planning to have everything completely sealed up (which introduces heat issues, particularly with my RPI4)?
Find
Reply


Messages In This Thread
RPI in marine environment, rust, corrosion, cases, etc. - by w7thmark - 2020-01-08, 05:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)