Posts: 47
Threads: 1
Joined: Feb 2020
Reputation:
0
Good morning, I have RPI4 with HAT2 and OpenPlotter V.2. Everything run. Now I would like to connect the various Raymarine type board, plotter Garmin, VHF, automatic pilot etc .. Protocols are SeaTalk, NMEA 0183 and NK2. They are several months that I am looking for and I'm not yet, but I still have not been able to find the solution. I do not find wiring schemes or clear information about it. Please if you can help me. In practice, what should I do now? Thank you.
Comet 1000 - Openplotter under construction
Posts: 47
Threads: 1
Joined: Feb 2020
Reputation:
0
Thank you Max1947. However it would be useful to have other tips, especially with schematics and wiring to be applied to a basic configuration with: RPI4 - HAT2 - openplotter v2 -. That is, the configuration followed on sailoog and rooco, using inexpensive hardware.
Comet 1000 - Openplotter under construction
Posts: 2,836
Threads: 60
Joined: Mar 2016
Reputation:
267
OP does not manage seatalk protocol, you need a seatalk-NMEA 0183 converter. To manage N2K you need a N2K to USB converter and for NMEA 0183 you need a RS422 to USB converter.
N2K config is done in CAN app, NMEA 0183 config is done in serial app. We are still writing the docs for these chapters. Any help is welcome.
Posts: 47
Threads: 1
Joined: Feb 2020
Reputation:
0
Many thanks Sailoog, I will take this into consideration.
Max1947, your proposed system seems feasible to me. But is it installable with HAT2 on the Raspberry4? Will I still need to use a Seatalk-NMEA0183 converter? For N2K and NMEA0183 protocols, do I have to set them as Sailoog says?
You are fantastic and fast. As soon as I have acquired the necessary notions I will proceed to wire everything and carry out the tests. Then I will publish the results.
Thank you
Comet 1000 - Openplotter under construction