2020-05-19, 04:07 AM
I'm using a Rpi 3, have been using Openplotter 1.2.0 with Open CPN 5 and have been slowly getting things working, but I'm pretty new at this stuff. It was suggested to upgrade to Openplotter 2.
I followed the instructions and downloaded Openplotter-v2-Starting-img.zip
I took a new 32 gig SD card and formatted it using the suggested formatting tool in the instructions
I copied NOOBS_lite_v3_3 to the new SD card
When I put the new card in the Pi and power up nothing happens. I get the red light on the Pi, but the green light never flashes as it usually does and the Pi doesn't boot up. If I replace the SD card with the older version, everything works fine.
Where did I go wrong? Thanks
I followed the instructions and downloaded Openplotter-v2-Starting-img.zip
I took a new 32 gig SD card and formatted it using the suggested formatting tool in the instructions
I copied NOOBS_lite_v3_3 to the new SD card
When I put the new card in the Pi and power up nothing happens. I get the red light on the Pi, but the green light never flashes as it usually does and the Pi doesn't boot up. If I replace the SD card with the older version, everything works fine.
Where did I go wrong? Thanks