2021-02-15, 09:29 AM
Hello guys,
I have an issue getting data from the NASA Wind sensor.
I have Openplotter V2 installed on RPI 3b+ and GPS, compass and BMP 280 sensor is working fine.
I use an Actisense USG2 USB Adapter which has one NMEA0183 input and one NMEA0183 Output. On the input I have connected the NASA Wind sensor and the output is connected to the VHF Radio to send position data to the VHF.
In the serial devices I can see the Actisense USB adapter under ttyUSB1 and I assigned the alias wndvhf to it and set the baud rate to 4800. I made a signal K connection.
I can't get the NME data from the NASA wind sensor into signal K. On the Adapter I can see the data flow from the sensor because the input LED is blinking. The output is working fine, the VHF get's the position data.
The input works fine on the OP version 1.2 alpha so I assume that there is no hardware problem. I configured the connection with Kplex. I tryed
How must I configure the adapter in OP V2 to get the data from the input? I tried to configure it in Kplex like in the 1.2 alpha version but it also doesn't work.
I have an issue getting data from the NASA Wind sensor.
I have Openplotter V2 installed on RPI 3b+ and GPS, compass and BMP 280 sensor is working fine.
I use an Actisense USG2 USB Adapter which has one NMEA0183 input and one NMEA0183 Output. On the input I have connected the NASA Wind sensor and the output is connected to the VHF Radio to send position data to the VHF.
In the serial devices I can see the Actisense USB adapter under ttyUSB1 and I assigned the alias wndvhf to it and set the baud rate to 4800. I made a signal K connection.
I can't get the NME data from the NASA wind sensor into signal K. On the Adapter I can see the data flow from the sensor because the input LED is blinking. The output is working fine, the VHF get's the position data.
The input works fine on the OP version 1.2 alpha so I assume that there is no hardware problem. I configured the connection with Kplex. I tryed
How must I configure the adapter in OP V2 to get the data from the input? I tried to configure it in Kplex like in the 1.2 alpha version but it also doesn't work.