2021-05-09, 08:17 PM
Hi Again,
After my success getting GPS to my VHF Radio I have began another project adding sensors to my OpenPlotter.
I have successfully installed an MPU 9250 via PyPilot using compass only and it works very well sending data to Signal K.
I also have a BME280 for environmental data (temp Pressure Humidity) which I have set up in I2C 2.2.1 and it is detected on address 0x77 and the connection is made to signal K on port 51000.
However Signal K is not detecting any data coming from the sensor.
I have followed the instructions here
https://openplotter.readthedocs.io/en/la...c_app.html
Could the module be faulty or is there anyway I can check that its working other than using Signal K.
Regards
D
After my success getting GPS to my VHF Radio I have began another project adding sensors to my OpenPlotter.
I have successfully installed an MPU 9250 via PyPilot using compass only and it works very well sending data to Signal K.
I also have a BME280 for environmental data (temp Pressure Humidity) which I have set up in I2C 2.2.1 and it is detected on address 0x77 and the connection is made to signal K on port 51000.
However Signal K is not detecting any data coming from the sensor.
I have followed the instructions here
https://openplotter.readthedocs.io/en/la...c_app.html
Could the module be faulty or is there anyway I can check that its working other than using Signal K.
Regards
D