This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
calibration screen in new OP image Using VNC , wrong
#1
Pypilot  calibration screen 
In the new OP image 64bit .
is wrong  . when using  VNC .

See  picture 


If i conect  a  HDMI screen   .   it  become  Ok  ,  both in HDMI and VNC  .

But after  disconect  of  HDMI  .  it become wrong again  in VNC   used from another computer .


   


RPI 3B ,  and Hacked HAT  ,

Danish
Sailing in a LM23  23" motor sailor i Danmark  .  Mostly In Koege bay  .
Harbored  in SF-Syd  , Copenhagen .
Marine Enginer  ,   Pt. working on power plant 
Reply
#2
This is a bug in vnc?

Can you run pypilot_calibration locally instead of on vnc? or use the web interface?
Reply
#3
(2023-08-06, 07:20 PM)seandepagnier Wrote: This is a bug in vnc?

Can you run pypilot_calibration locally instead of on vnc?  or use the web interface?

I can run  pypilot_calibration locally   it works  when i have connected af HDMI screen . 

Is the same bug affecting  Chromium Netbrowser  ?   
I have to install Firefox  to start Signal K   .
Sailing in a LM23  23" motor sailor i Danmark  .  Mostly In Koege bay  .
Harbored  in SF-Syd  , Copenhagen .
Marine Enginer  ,   Pt. working on power plant 
Reply
#4
I mean you can run pypilot_calibration on any machine and pass it the ip address of the one with pypilot.

if you have the pypilot_web service started you can use a browser to view the calibration that way.
Reply
#5
(2023-08-06, 08:37 PM)seandepagnier Wrote: I mean you can run pypilot_calibration on any machine and pass it the ip address of the one with pypilot.

if you have the pypilot_web service started you can use a browser to view the calibration that way.

I tried to enable  pypilot_web  .   but now   i have lost the Pi  on the network  .  
There is bad weather here i denmark  , so  i will first be on my boat  ,  in wensday  i think .
Sailing in a LM23  23" motor sailor i Danmark  .  Mostly In Koege bay  .
Harbored  in SF-Syd  , Copenhagen .
Marine Enginer  ,   Pt. working on power plant 
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)