2024-03-06, 06:28 PM
Hello,
Not sure if it's OP issue,
I've got the AP configuration, and works fine and can share internet. Can connect with my phone and other devices that are 2.4 only.
Although I've selected authe method as WPA/WPA2 Personal The AP is advertised as the WSP WPA network.
SensESP can detect the network, but fails to connect, returning a connection status of 1 (WL_NO_SSID_AVAIL). However, it works fine and can connect to that AP when I remove authentication from the access point and make it open. Therefore, I assume the issue lies with the inability of SensESP to authenticate using WPA. I couldn't find a way to forse WPA2 authentication on OP access point. Is there any config changes that I can do to force the auth protocol.
Not sure if it's OP issue,
I've got the AP configuration, and works fine and can share internet. Can connect with my phone and other devices that are 2.4 only.
Although I've selected authe method as WPA/WPA2 Personal The AP is advertised as the WSP WPA network.
SensESP can detect the network, but fails to connect, returning a connection status of 1 (WL_NO_SSID_AVAIL). However, it works fine and can connect to that AP when I remove authentication from the access point and make it open. Therefore, I assume the issue lies with the inability of SensESP to authenticate using WPA. I couldn't find a way to forse WPA2 authentication on OP access point. Is there any config changes that I can do to force the auth protocol.