2024-03-26, 08:24 PM
(2024-03-26, 11:03 AM)Sailoog Wrote:On the same RPi5 but a Raspberry image I tried to install SignalK(2024-03-26, 10:36 AM)Hakan Wrote: About the SignalK (npm) update issue reported here: https://forum.openmarine.net/showthread....6#pid29066
I have created a new image, on a 32 GB SD card, using "2023-12-29-OpenPlotter-v4-Starting-beta-64bit-img" created by "Raspberry Pi imager" on a Rpi.
On the new image I changed localization settings like Timezone(ETC+1), keyboard (SE), wifi country(SE) and nothing more.
I also updated the system by "update" and "full-upgrade"
The I ran "Signal k Installer" and got the same result as before. Each update attempt, e.g.: "npm GET 200 https://registry.npmjs.org/socket.io.parser", is timed out as before.
Any advices what to test next?
/Håkan
I will try to reproduce that.
Method used:
1. In RPi inbound program installer I installed nodejs and npm.
2. sudo npm install -g npm@latest >> Works fine. Some files updated.
3. sudo apt install libnss-mdns avahi-utils libavahi-compat-libdnssd-dev -y >> All was already installed.
4. sudo npm install -g --unsafe-perm signalk-server -y >> Worked.
5. Then I could setup and start SignalK wo problem
On the Openplotter image:
1. nodejs was installed. npm not, so I selected that and Apply.
2. Didn't worked. The command was "swallowed" but nothing happened. I'd to close the hanged terminal.
3. All deps. was already installed.
4. Didn't worked.