How to use 1W data?

[jim321]

"opencpn defaults does not insert the 1W sensors"

i does for me i just reinstalled today and all i did was add the defaults in nmea0183 gen and changed it to fahrenheit then added temperature to dash on open cpn. shows up in open cpn on raspberry pi and on my laptop's open cpn getting data thru openplotter's ap..
check your settings in open cpn connections..
also a reboot may be required ..?
thats all i can think of that could be a problem

these are temperature's that are installed with default setting, bottom one is water temp.
   

one wire setup
   
jim