Good morning.
This morning I downloaded Noobs for Openplotters.
I formatted a sd-card with SD-Formatter and unzipped the
file to the freshly formatted sd-card.
I put the card into my Raspberry Pi 2 rev. B and switched Power on.
Immidiately the Green LED lighted without a break.
After 30 minutes I shut down.
Is this hanging on boot a known problem?
Is there any help?
Regards
Karl
After unzipping you must move the files away from the directory "Openplotter" to the upper level. Otherwise it won't boot.
Lähetetty minun TA-1032 laitteesta Tapatalkilla
" unzipped the
file to the freshly formatted sd-card."
unzip in same folder
open the unzipped folder to NOOBS_v2_8_1 open that to show all those files select all copy paste to a fresh formatted card
if you unzip strait to the card those files are two folders deep and it wont see them to start the boot
(2018-06-03, 11:32 AM)CottageCruiser Wrote: [ -> ]After unzipping you must move the files away from the directory "Openplotter" to the upper level. Otherwise it won't boot.
Lähetetty minun TA-1032 laitteesta Tapatalkilla
Yes, I moved the files outside the folder and deleted the (now empty) folder.
(2018-06-03, 11:32 AM)jim321 Wrote: [ -> ]" unzipped the
file to the freshly formatted sd-card."
unzip in same folder
open the unzipped folder to NOOBS_v2_8_1 open that to show all those files select all copy paste to a fresh formatted card
if you unzip strait to the card those files are two folders deep and it wont see them to start the boot
Yes, I moved the files outside the folder and deleted the (now empty) folder.
And there were no folders anymore, just plain files?
Lähetetty minun TA-1032 laitteesta Tapatalkilla
(2018-06-03, 12:07 PM)CottageCruiser Wrote: [ -> ]And there were no folders anymore, just plain files?
Lähetetty minun TA-1032 laitteesta Tapatalkilla
No, I see 3 folders
- defaults
- os
- overlays
and 18 plain files
Thank you very much
Karl
(2018-06-03, 04:29 PM)waldmattis Wrote: [ -> ] (2018-06-03, 12:07 PM)CottageCruiser Wrote: [ -> ]And there were no folders anymore, just plain files?
Lähetetty minun TA-1032 laitteesta Tapatalkilla
No, I see 3 folders
- defaults
- os
- overlays
and 18 plain files
Thank you very much
Karl
Was your sd formatted as FAT32?
Lähetetty minun TA-1032 laitteesta Tapatalkilla
(2018-06-03, 04:57 PM)CottageCruiser Wrote: [ -> ] (2018-06-03, 04:29 PM)waldmattis Wrote: [ -> ] (2018-06-03, 12:07 PM)CottageCruiser Wrote: [ -> ]And there were no folders anymore, just plain files?
Lähetetty minun TA-1032 laitteesta Tapatalkilla
No, I see 3 folders
- defaults
- os
- overlays
and 18 plain files
Thank you very much
Karl
Was your sd formatted as FAT32?
Lähetetty minun TA-1032 laitteesta Tapatalkilla
I will Check that.
Thx
Karl
It takes 30-60 min for the first NOOBS install.
maybe longer with a Raspberry Pi 2 rev. B